Voltmeter Gauge with Stainless Steel Bezel

The Voltmeter Gauge with Stainless Steel Bezel is a classically styled black gauge with white writing, an analogue white needle and a shiny stainless steel bezel, it is also waterproof, perfect for classic boats such as Freeman Cruisers.

The voltmeter gauge has a scale from 8 volts to 16 volts to show the amount of voltage in your 12 volt system. The gauge will show you the voltage in your batteries and whether the batteries are being charged by the alternator.

This classic voltmeter gauge comes complete with built-in led backlight illumination in either yellow or red light and is designed for use on 12 volt systems only. It also comes complete with a wiring loom with a quick connect plug to make fitting easier.

Waterproof Voltmeter Gauge

This voltmeter gauge has an IP (Ingress Protection) rating of IP67 which means it is completely sealed from dust and is waterproof as it is protected against temporary immersion in water (up to 30 minutes).

Voltmeter Gauge with Stainless Steel Bezel Installation

The gauge requires a 53mm hole and will fit panels with a thickness from 0.5mm to approximately 20mm, this is achieved thanks to the long threaded body and large plastic nut to lock the voltmeter in position.

The wiring loom is pre-wired to a plug which pushes into the back of the gauge, only three wires are required, Positive, Negative and then either of the back light wires, which can also be put through a switch to provide day time (yellow light) and night time (red light) illumination.

Voltmeters and Split Charge Systems

If you have a split battery system using a split charge diode then you may require multiple voltmeters, one for each bank of batteries, this will then show you the voltage in each bank and whether they are receiving charge.